Ferrari 599 C1396 Engine Trouble Code
What is Ferrari 599 C1396?
The Ferrari 599 C1396 check-engine light can indicate issues ranging from minor (loose gas cap) to serious (catalytic converter failure). Professional diagnostic scanning at a dealer or shop will identify the exact cause and required repairs.
C1396 on the Ferrari 599
The Ferrari 599 ECU flash version prior to the 2.4.1 update has a known calibration bug that can generate spurious C1396 codes under hard deceleration. Verifying the ECU software version is always the first step before any mechanical diagnosis on this model.
Code Information
| Code Type: | OBD-II Chassis (C) Trouble Code |
| System: | Chassis |
| Vehicle: | Ferrari 599 |
| Brand: | Ferrari |
| Model: | 599 |
| Code: | C1396 |
C1396 Ferrari 599 Symptoms
Check Engine Light
Illuminated Ferrari 599 dashboard warning
Engine Stalling
Engine stops unexpectedly or misfires
Performance Issues
Reduced power or acceleration on the Ferrari 599
Starting Problems
Difficulty starting the engine
Poor Fuel Economy
Increased fuel consumption on the Ferrari 599
Increased Emissions
Failed emissions test due to C1396
C1396 Code Structure
Understanding what each digit means in the C1396 chassis trouble code:
| C | 1 | 3 | 9 | 6 |
|---|---|---|---|---|
| Chassis Code | Fuel And Air Metering | Throttle/Pedal Position Sensor/Switch A Circuit Intermittent | Crankshaft Position Sensor A Circuit Malfunction | Ignition Coil A Primary/Secondary Circuit Malfunction |
How to Fix Ferrari 599 C1396
Diagnostic Steps:
Check if fuel pump primes when key is turned to ON. Measure fuel pressure and verify bright white-blue spark at all plugs. Also verify mechanical timing alignment.
Repair Solution:
Disconnected, dirty, or fouled spark plugs commonly prevent proper engine operation. Replace spark plugs every season or 25 hours. Verify proper spark plug gap. If plugs are good, check ignition components: spark plug wires, coils, and ignition module.
Technical Notes:
Parts or components should not be replaced based solely on C1396 DTC. Consult your vehicle service manual for proper diagnostic procedures, possible causes, and required testing before replacement.
Ferrari 599 C1396 Repair Cost
Replacing the lambda (O2) sensor wiring loom section on the Ferrari 599 costs $90–$160 at a body shop or auto-electrician. This is far cheaper than replacing the sensor itself when the sensor is otherwise functional — always inspect wiring before condemning sensors.
C1396 Description
C1396 engine trouble code is related to Ignition Coil A Primary/Secondary Circuit Malfunction.
Main Cause
The primary reason for C1396 OBD-II Engine Trouble Code is: Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.
Common C1396 Misdiagnosis on the Ferrari 599
On the Ferrari 599, the EGR cooler is sometimes replaced for C1396 when the EGR valve position sensor is at fault. The two components share a fault pathway in older scan tools that do not display live EGR valve position data.
DIY Repair Guide: C1396 on Ferrari 599
After any repair that involved disconnecting the battery on the Ferrari 599, the power window, steering angle sensor, and transmission adaptive values all require a reset drive cycle. Skipping this can cause false fault codes — including C1396 — for the first two to three start cycles.
Preventing C1396 on the Ferrari 599
Transmission fluid degradation on the Ferrari 599 directly affects solenoid operation. Replacing ATF at 40,000-mile intervals (rather than the often-quoted 'lifetime fill' recommendation) is the best insurance against shift-solenoid codes including C1396.
Frequently Asked Questions — Ferrari 599 C1396
A: Yes. Any stored fault code — including C1396 — will cause an automatic failure in most OBD-II based emissions tests. The code must be resolved and the vehicle must complete a full OBD drive cycle with no new codes before the test.